AA4C Auto frame rectifier car chassis straightener auto collision repair system AA-ACR600

1.Simple Auto body rectified equipment
2.car frame bench
3.car repair bench
4.auto body repair system
5.auto repair bench

Features:

You can load and setup a damaged vehicle in under 10 minutes and be ready to start the repair. You can stand up while changing fenders, the front or rear bumper, hood and other body components. You have easy access to all of the suspension. You have wide open access to the underside of the engine compartment, as well as the underside of the vehicle. Unlike large frame machines that block most of this area because of their size and design. Most of the repairs are of the light to moderately damaged type.It is a much smaller and faster repair system.

1. Completely mobile, use it in the shop, parking lot, wherever pulls are needed
2. The ultimate in versatility
3. 5-ton pulling system with 10 ton hydraulics
4. Full 180 degree swivel for side, front & rear pulling
5. Post swivels 90 degrees for extended reach
6. Multiple position set-ups allow for all kinds of pulls
7. Secure four point clamping system, more firm.
8. Includes down-pull attachment
9. No tie downs or anchor pots needed
10. Fast, easy one man set-up
11. Includes one foot pump
12. With four stands.

Specification:

Length----------3500mm/11'6"
Height-----------220mm/8.7"
Width----------2000mm/6'7"
Radius of pulling-----------180⁰
Hydraulic maximum power-----70Mpa
Air supply required---------0.8Mpa
Pulling tower capacity----------98KN
Total weight-------------500kgs